This command reports station or elevation information on a 3D polyline. If the station information is entered the program will return the elevation at the entered station. If the elevations are entered the program will determine and report the station at which the entered elevation occurred. If the elevation entered occurs at more than one location along the 3D polyline, all occurrences of the elevation are reported.
A prompt is provided allowing you to designate a starting station, or accept the default value of <0.0>. All entry and values are recorded and are displayed in the Carlson Standard Report Viewer upon completion.
Select 3D polyline to report:
pick a polyline
Starting Station <0.0>: press Enter
Enter elevation or station (<Elevation>/Station)?
S
Enter Station to calculate elevation: 100
Station: 1+00.000
Elevation: 1052.262
Enter Station to calculate elevation (Enter to end):
press Enter
Select 3D polyline to
report: pick a polyline Starting Station <0.0>:
press Enter
Enter elevation or station
(<Elevation>/Station)? E
Enter Elevation to find
stations: 2140
Enter Elevation to find
stations: 2144
Enter Elevation to find
stations: 2150
Enter Elevation to find stations
(Enter to end): press
Enter
Pulldown Menu Location:
3D Data
Keyboard Command:
plreport3
Prerequisite: A 3D
Polyline