This command draws +/- symbols along fault lines. The + is on
the upside and - on the downside of the fault. The program prompts
for the Layer for the symbols and the Symbol Size Scaler which is
multiplied by the current drawing horizontal scale to set the
symbol size. Then the program prompts to select the fault polyline
to label. Then the program draws the symbols at points picked along
the fault.
Draw Fault Symbols dialog
Select fault polyline for symbols: pick a fault
polyline
Pick point for symbol: pick a point along the
fault
Pick point for symbol (Enter to end): press
Enter
Select fault polyline for symbols (Enter to end):
press Enter
Prerequisite:
Fault polyline
Pulldown Menu Location: StrataCalc > Faults
Keyboard Command: fault_sym