Fill-in Bed Names

For some methods of processing the strata modeling routines, the drillhole set should have either no duplicate strata names or bed names assigned for each strata. When bed names are assigned to the key strata (or just some strata within drillhole), the blanks may be filled-in using this routine. The routine works from the top of the drillhole down until it finds the first strata with a non-empty bed name. That bed name is then applied to all strata with empty bed names above that strata. This procedure is then repeated to the bottom of the hole. For the strata below the last strata with bed name assigned, the last bed name is used.

Pulldown Menu Location: Drillhole > Strata/Bed Utilities
Keyboard Command: fillbed