This command revises a segment of a polyline. Begin by picking a point on the polyline where you want to start editing. Then pick new points for the polyline. When finished picking new points press Enter, and then pick a point on the polyline to connect with the new points. The polyline segment between the start and end points is then replaced with the new points.
Select polyline to edit: pick the polyline at the
place to start editing
Pick intermediate point (Enter to End): pick a
point
Pick intermediate point ('U' to Undo, Enter to End): pick
a point
Pick intermediate point ('U' to Undo, Enter to End):
press Enter
Pick reconnection point on polyline: pick the polyline at
the place to join
Edit this contour by picking new points |
Contour with segment replaced with new points |
Pulldown Menu Location: Edit > Polyline Utilities >
Edit Polyline
Keyboard Command: editpl2
Prerequisite: Polylines