This command draws an arc, given the PC point, radius length, chord length and chord bearing. The PC point can either by picked on-screen or specified by point number. Given these points, the arc can be drawn clockwise or counter-clockwise. The program shows one direction and asks if it is correct. If you need the arc to go the other direction, enter No.
Radius of Arc <-40.00>: 500
PC Start Point ?
Pick point or point number: pick a point
Chord bearing or chord endpoint (<Bearing>/Point)?
Press Enter
Enter Bearing (Qdd.mmss) <90.0000>: 145.1041
(for NE 45d10'41")
Chord Length <200.46>: 200
Is this arc in the correct direction (<Yes>/No)? Press
Enter
Pulldown Menu Location: Draw > Arc
Keyboard Command: srcb
Prerequisite: None