Curve
This feature allows you to Draw a table containing curve
information for specified curves.
You will be prompted to open a coordinate file if one is not
already open. Once the coordinate file is open, the Curve Table
Settings dialog box will appear. The Curve Table
Settings dialog allows you to configure the following settings:
Curve Components
Check the checkboxes for the curve components that you wish to
appear in the table, Radius, Tangent, Arc Length, Chord Bearing,
Delta, Degree and Chord.
Drawing Settings
Enter the layer, text size and line spacing, and check or uncheck
the Use Foot Symbol checkbox.
Layer: CG_Template
Text Size: 0.100
Line spacing: 0.075
Curve Labels
Enter the First Curve Label for the first curve
First Curve Label: C1
Automatically increment curve
label: check or uncheck the Automatically increment curve
label checkbox.
OK Button: When done, click
OK to begin entering the curve data.
Prompts
You will be prompted at the command line to Enter point
sequence
Picked C&G Point
[1444]
Enter point sequence
[cLockwise_curve/ccW_curve/Reset/turn_Snap_on] (last point = 1444):
L
Enter radius point for curve
[Reset/turn_Snap_on]:
Picked C&G Point [1449]
Enter point of tangency (PT) for
curve [Reset/turn_Snap_on]:
Picked C&G Point [1448]
Move Curve Table to desired
location: Drag Table to desired location and Left-mouse
click to place on the drawing.
Note:
After entering the PT point for any curve, you can continue
entering curve data. However, you should be aware that the PT point
is shown as the last point.
If the PT point is not the PC of the next curve then you need to
enter “R” for Reset. This allows you to begin the next curve
at a new PC, then continue on to enter its radius point and PT.
Pulldown Menu Location:
CG-Survey > CGDraw>Tables>Curves
Keyboard Command: CURT,
CG_CURVE_TABLE
Prerequiste:
Coordinate file