Apply Faults to Grid

This command is used to offset the grid values of an existing grid file. It saves a new grid file with the values offset based on the fault lines drawn with the Draw Faultline command. The Fault Influence Distance is the offset distance away from the faultlines that will be used to transition from the original grid to the faulted values.

gridbefore This is the grid before applying the faults

gridafter This is the grid after applying the faults

Prompts

Fault Influence distance <500.00>: 150 Enter in distance to use.
Select fault lines:
Select objects: Specify opposite corner: 3 found Select the fault lines
Updating grid with faults 190000...
Writing grid> C:\Carlson Projects\C2 Grid with Faults.grd
Writing cell> 192240

Pull down Menu Location: StrataCalc
Keyboard Command: apply_faults
Prerequisite: fault lines drawn using Draw Fault Line and a grid file