This command converts Civil 3D point entities into Carlson
format point entities. When running in AutoCAD, the Civil 3D Object
Enabler from Autodesk is used to read the Civil 3D point entities.
This object enabler must be installed before running this routine.
The installation for the object enabler is located under Support at
www.autodesk.com. When running in IntelliCAD, this routine uses a
conversion program from the Open Design Alliance to read the Civil
3D point entities.
Pulldown Menu Location: Points > Convert Point
Format
Keyboard Command: c3d_crd
Prerequisite: Civil 3D points in the drawing