Draw Pillars creates a polyline in the PILLARS layer out of the
points you pick. These points
should compose the perimeter of a pillar. It is necessary to end
picking points by entering C in order to
make a closed polyline. Otherwise, inaccurate tonnages may result.
Before using this routine, the
points to connect can be placed using one of the Mine Note Entry
commands. If, after drawing a series of pillars, you want to
check to see that all of the pillars have been properly closed, use
the Highlight Unclosed Polylines under the Works dropdown menu.
[node on] First Point: pick a point
Next Point, U to Undo, C to Close: pick a point
Next Point, U to Undo, C to Close: pick a point
Next Point, U to Undo, C to Close: pick a point
Next Point, U to Undo, C to Close: C to close
Pulldown Menu Location: Works
Keyboard Command: pillars
Prerequisite: None
File Name: \lsp\pillars.lsp