Input - Edit Trench Template
Function
This command lets you create a new
trench template or modify an existing trench template. It prompts you
the Input-Edit Trench Template Dialog.
If you are modifying a trench template,
click the Load button on the
dialog to open a trench template file and display the template data on
the dialog. Enter the dimensions of the trench: bottom offset, trench
width and vertical side
height. The Edit Trench Benches button will bring up the below dialog,
and allows you to enter in up to four benches into your trench.
There are three methods for entering the cut
slope, Percent, Ratio and Degree. Choose one of the methods and enter
the slope value. Display Sewer Structure allows
you to see your pipe or manhole as part of the trench. This is
for display purposes only, calculations will be drawn from the pipe
size you set in the Trench Network Structure commands. Add Pipe
Diameter To Trench Width will increase the size of your trench by the
diameter of your different pipe sizes. There are three trench bottom
backfill layers that can
be defined. Enter the layer label in the material name field, the depth
of the layer in the thickness field. Click Save or SaveAs to save the
template information in a .tch file, and Click Exit to quit this
command.
Prompts:
Input-Edit
Trench Template Dialog
Enter the dimensions of the trench template, save the information to a
template file (.tch).
Prerequisite:
None
Keyboard Command:
make_trench_tpl