Loading edges...
Loaded 41041 points and 122901 edges
Created 81859 triangles
Loading edges...
Loaded 5487 points and 16332 edges
Created 10846 triangles
Initializing Draw Profile command ...
Draw Sewer Profile Dialog
Enter drawing parameters such
as Grid scale, text scaler, starting and ending stations etc. for
drawing the sewer profile.
Enter general sewer profile settings
such as
elevations (Rim, Invert-In, Invert-Out) to draw and label.
Use the Manhole tab to define what
manhole information is labeled in your trench profile.
Use the Pipe tab to define what
piping information is labeled in your trench profile.
The command will find the elevation
range of your profile and display it at the top of this dialog. Here
you can set the elevation top and botton of the profile's grid.
Prerequisite: Your drawing is open, has been cleaned
up and pre-processed by such
commands as Define Layer Target, Set Boundary Polyline, Make Existing
Ground Surface and Make
Design Surface. Trench structure data has been stored
in a .sew file, whose name is as same as the drawing name.