Other Drawing
Function
This command allows you to display all the entities on the layers that
are grouped as
part of the Other drawing.
Carlson TakeOff allows you to assign layers into three different
"Target" surface groups: Existing, Design, and Other. For more about
assigning layers to different "Target" surface groups see Define Layer
Target/Material/Subgrade under the tools menu. Once layers have been
assigned, the display menu allows for easy viewing of each "Target"
surface. Typically, most layers are listed under Other before they are
assigned to Existing or Design. Some layers, like perimeter, are
neither apart of the Existing or the Design drawing so they remain
under Other. When Other Drawing is checked than the entities grouped
under Other will be displayed. If it is not checked it will not be
displayed. You
can check on and off the other "Target" surfaces to view the Other
surface in isolation or in accordance to the other surfaces. In this
example, Existing, Design, and Other are all shown.
Keyboard
Command: set_display_other_dwg
Prerequisite:
Define Layer
Target/Material/Subgrade