Perimeter
Function
Perimeter is a 2D polyline that all
points on it have the same elevation. It can be used as boundary
polyline of your targets on your drawing. This command allows you to
digitize a perimeter by picking points on the
drawing. While digitizing a polyline, the command
keeps prompting you to pick next point until your press Enter to
finish digitizing, or press A
on the puck or enter Close on
the keyboard to close the polyline on itself . If you make a mistake, press B
on the puck or enter
Undo on the keyboard to remove the mistake and then continue to
digitize. After finishing a perimeter, the command prompts your to
digitize another polyline until you press
B or enter No.
Prompts
First point: pick a point on the drawing using puck
Segment length: 0.00, Total length:
0.00
Close[A]/Undo[B]/Pick next point
(Enter to end): pick next point
Segment length: 104.27, Total length: 104.27
Close[A]/Undo[B]/Pick next point
(Enter to end): pick
next point
Segment length: 153.14, Total length: 257.41
Close[A]/Undo[B]/Pick next point
(Enter to end): pick
next point
Segment length: 104.89, Total length: 362.30
Close[A]/Undo[B]/Pick next point
(Enter to end): press Enter to finish the perimeter, or
press A to close the perimeter
Digitize Another PERIMETER Polyline
[Yes(A)/<No(B)>]? press A or enter Yes to continue
digitizing another perimeter, press B or enter No to finish digitizing
perimeters.
Keyboard Command: dig_perim
Prerequisite: Have a
digitizer board and a puck connected to your computer, and have Wintab
driver installed. The digitizer has been correctly set up. Have done
tablet calibration for
current drawing.