This command creates a point at the user-entered coordinates. The point is both stored to the current coordinate (.CRD) file and drawn on the screen. The program will prompt for the northing and easting. This routine will prompt for point number, elevation and description, depending on the settings in the Point Defaults command. Point Defaults also allows you to set the point symbol and layer. Point Defaults is found under the Points pulldown.
Enter North(y): 5000
Enter East(x): 5000
Select/<Enter Point Elevation <0.00>: Enter 100 for
elevation,
or press S and enter to select text to set elevation.
Enter Point Description <>: START
N: 5000.00 E: 5000.00 Z: 0.00
Enter North(y): press Enter to end
For instruction on how to insert either new or existing points into
the drawing, see Draw-Locate Points in the Points Commands section of
the General Commands chapter. This feature can be found in the Points
pulldown of all menus.
Pulldown Menu Location: COGO
Keyboard Commands: eapoint, ea
Prerequisite: None
File Name: \lsp\eapoint.lsp