This command generates a report of the bearing and horizontal
distance between a series of
points, and calculates the area of the closed figure defined by the
points. Curve data can also be
entered and reported. The points can be either picked on the screen, or
entered by point number. You
can also enter a range of point numbers (i.e. 1-9). The
closure is reported using the total distance inversed, and the
difference between the starting
and ending points, as the closure error. There is an option
in Area Label Defaults to report the distances in both
feet and meters. The area can be labeled in the drawing
using the settings from the Area Label
Defaults command. If you don't want to label the area, press Enter
at the
pick label point prompt. This command creates a polyline
of the figure which can be erased or kept in the drawing.
Station/<Pick Starting point or
point number>: pick a point
Pick point or point numbers
(R-RadiusPt,U-Undo,Enter to end): pick a point
Pick point or point numbers
(R-RadiusPt,U-Undo,Enter to end): R for radius
Radius point number or pick point: pick a point
Curve direction
[Left/<Right>]? press Enter
Pick End of Arc or point number
(U-Undo,Enter to end): pick a point
Pick point or point numbers
(R-RadiusPt,U-Undo,Enter to end): pick a point
Inverse with Area 05/19/2005 13:07
CRD File> c:\scad2006\data\newplat.crd
PNTNO BEARING DISTANCE NORTHING EASTING STATION DESC
903 4940.73 2490.40 0.00 StartPt
S 48°43'58" W 136.21
904 4850.89 2388.01 136.21
S 13°07'04" E 155.56
905 4699.39 2423.32 291.77
S 73°55'04" E 165.34
906 4653.59 2582.19 457.11
RADIUS: 111.45 CHORD: 204.07 DEGREE: 05°08'28" DIR: LEFT
LENGTH: 257.86 DELTA: 132°33'53 TANGENT: 253.67
CHORD BRG: N 39°47'59" E RAD-IN: N 16°04'56" E RAD-OUT: S 63°31'03" W
RADIUS PNTNO: 907 N: 4760.67 E: 2613.06
908 4810.37 2712.82 714.97 IP
N 26°28'57" W 125.87
909 4923.03 2656.69 840.84
N 83°55'30" W 167.23
903 4940.73 2490.40 1008.07 StartPt
Closure Error Distance> 0.0000
Total Distance Inversed> 1008.07
AREA: 74664.6 SQ METERS
Point number (R-RadiusPt,U-Undo,Enter to end):
pick a point
Point number (R-RadiusPt,U-Undo,Enter to end):
pick a point
Point number (R-RadiusPt,U-Undo,Enter to end): press Enter
SQ. FEET: 27247.4 SQ. YARDS: 3027.5 SQ. MILES: 0.0
ACRES: 0.63 PERIMETER: 668.35
Pick area label centering point: pick a point
Erase Polyline Yes/No <Yes>: press Enter The
command plots a polyline that represents the
figure you defined if you want to keep the polyline respond with No.
Pulldown Menu Location: Area/Layout
Keyboard Command: ia
Prerequisite: None
File Name: \lsp\ia.lsp