This command revises a segment of a contour polyline. Begin by picking a point on the contour where you want to start editing. Then pick new points for the polyline. When finished picking new points, press Enter and then pick a point on the contour to connect with the new points. The polyline segment between the start and end points is then replaced with the new points.
Select contour to edit: pick the contour polyline at the
place to start editing
Pick intermediate point (Enter to End):
pick a point
Pick intermediate point ('U' to Undo, Enter to End):
pick a point
Pick intermediate point ('U' to Undo, Enter to End): press
Enter
Pick reconnection point on contour: pick the contour
polyline at the place to join
Edit this contour by picking new points |
Contour with segment replaced with new points |
Pulldown Menu Location: Surface > Modify Contours
Keyboard Command: editctr
Prerequisite: Polylines with elevation (contour polylines)
File Name: \lsp\poly3d.arx