Cut/Fill Width Analysis

Function

This command generates a report of the horizontal width of cut and fill areas between two cross sections. The report generated can take into account the cut, the fill or both. The options for this command are set in the dialog shown. The width of each area is reported at different elevations set by the Elevation Interval. The elevation is calculated for where the area has the Target Width. The average width and height is calculated for each area.

Prompts

Section File (Existing Ground) dialog choose existing .SCT file
Section File (Final Ground) dialog choose the other existing .SCT file
Cut/Fill Analysis dialog Make selections.
Cut/Fill Section Report is created.

Width Analysis Report:

Cut/Fill Section Report
Target Width: 20.00
Section 1: C:\scad2006\data\simo2.sct
Section 2: C:\scad2006\data\final.sct
Station: 0+10.000
Fill Area: 153.289
  Target Width at 108.07
  Area Above Target Width: 72.48
  Area Below Target Width: 80.81
  Average Width: 12.19
  Average Height: 2.95
  Elev: 110 Width: 25.97
  Elev: 105 Width: 10.65
  Elev: 100 Width: 2.86
  Elev: 95 Width: 0.00

Pulldown Menu Location: Sections > Cut/Fill Analysis
Keyboard Command: cfwidth
Prerequisite: Two section .SCT files
File Names: \lsp\regrade.arx, \lsp\cfwidth.lsp