This command reads a centerline (.CL) file and plots it as a 2D
polyline
in the drawing at the proper coordinates. First you are prompted for
the layer name for the polyline to be created. There is also an
Options choice that allows you to specify whether to draw PI lines, and
specify the length of same.
Next you are prompted for the file name of the centerline to plot.
The .CL file can be made with the following commands on the Design
menu:
Polyline to CL File, Input-Edit Centerline or Design Centerline.
Drawing the centerline file is a way to check the .CL file data
graphically
for correctness. If a spiral exists in the .CL file, the spiral will be
represented
by polyline segments.
Options/Layer Name for Centerline <CLINE>: press
EnterEnter
the layer name to plot the polyline on.
Centerline File to Plot file selection dialogSelect the .CL file
name to read and plot.
Pulldown Menu Location: Centerline
Keyboard Command: cl2pline
Prerequisite: a centerline file
File Name: \lsp\clpline.lsp