The first is called a
Template Series, in which multiple Templates are assigned to a single
Centerline at different stations. Next
is a Template transition, in which a single Template is assigned to the
entire
Centerline and the user edits it at different stations.
Next is a Template Point Centerline, in which
a secondary Centerline is defined and attached to a point on the
Template for
specific horizontal control, such as a lane widening.
Last is a Template Point Profile, in which an
additional Profile is defined and attached to a point on the Template
for
specific vertical control, like the flow line of a ditch.
Superelevations – The
template breakpoints for
superelevation pivots are defined within Design Template. The stations
for the
superelevation transitions are set in the Input-Edit Superelevation
command.