Block Diagram creates a 3D cut out of the site with
contours and/or grid mesh on top and fence diagrams or solid faces on
the sides.
The options for griding and contours are shown in the first dialog
box. The second dialog shows the options for the fence diagrams
and grid. The strata hatch patterns are defined in the Define Strata
command. The default hatch pattern at the bottom of the dialog is used
if there is no pattern defined for that strata. In order to process a
strata for the fence diagrams, there must be at least one drillhole
inside
and at least one outside the block diagram box. This command is
basically a 3D Fence Diagram, with grid faces or contours on top. All
of these options are defined in Make 3D Grid File and Draw Fence
Diagram.
Pick or enter Lower Left block corner:
Pick or enter Upper Right block corner:
Reading cell> 194032
Pass> 7 Null Z values left> 0
Calling fence
Drawing strata OVERBURDEN
Drawing strata C1
Drawing strata PARTING
Drawing strata C2
Drawing grid text ...
Reading cell> 194032
Converting edges ...
Starting contour elevation <4610.0000000>:
Ending contour elevation <4920.0000000>:
Contouring elevation 4920.0000000
Pulldown Menu Location: StrataCalc in Advanced Mining
Keyboard Command: blockdia
File Names: \lsp\blockdia.lsp, \lsp\makegrid.lsp, \lsp\makegrid.arx,
\lsp\corehole.dcl, \lsp\cntr_grd.arx