This command is used to highlight, isolate and/or zoom to
layers that are selected from a docked list. This command is ideal when
you are working on a very dense and complex drawing, which has many
layers. In some cases, there will be layers that you would want to
erase. And another scenario might be that you'd like to highlight a
layer that is hard to find and see.
At the bottom of this special interface
screen is the control panel that is shown below. Note the selectable,
scrolling layer list on the far-left side. Once a layer is selected,
Pulldown Menu Location: Inquiry
Keyboard Command: layer_inspect
Prerequisite: None
File Name: \lsp\contour4.arx