Polyline by Nearest Found

Function

This command draws a polyline by connecting points using a nearest found method. The points to connect can be specified either by entering point numbers or picking POINT entities on the screen. The nearest found method draws a polyline by starting at one of the points and then connecting to the closest of the remaining points. Then a remaining point that is closest to one of the polyline end points is added until all points are part of the polyline.

Prompts

Create 2D polyline at zero elevation or 3D polyline [<2d>/3d]? press Enter
Select point from screen or by point number (<Screen>/Number)? press Enter
Select points.
Select objects: pick points