This command creates a report of cut/fill slopes and
distances of a design surface from a starting point. First
you move to the starting point and then take a reading from
the instrument to get the starting point coordinates. This
starting position is shown in the drawing. Next you pick a
point in the drawing to define the direction. The drawing
should contain the design surface entities. The program will
then calculate all the intersections with contours and 3D polylines between these two points.
The resulting horizontal distances and slopes are shown in a report dialog. From this dialog, there
is an option to stakeout one or two offset points set back from the starting point at the
specified offsets.